Created with Sketch. Created with Sketch.

Torque Controllers

Madjax Support Torque Controllers FAQs

Q: Will the 600 amp controller drain my battery quicker than a 400 or 500 amp controller?

A: Yes and No, the controller is only going to supply as much current as you need, so it will draw higher current when under a load, like going up a hill or coming out of a ditch. On average the controller will not consume anymore power than your stock controllers. That being said, if you are trail riding up and down hills and constantly being under heavy load then yes, it will drain the battery pack quicker.

 

Q: Do I need to install larger wires and higher amperage solenoid?

A: No, our controller is designed to work with stock wires and solenoids. You can upgrade your wires and solenoid to decrease heat build up but it is not required.

 

Q: My OTF programmer is not responding when I change the settings.

A: Make sure the programmer is not locked. Also verify that the programmer has not come unplugged from the controller.

 

Q: Will the Torque controller make may cart go faster?

A: It will make a stock cart go faster. Basically our controller allows the motor you have to run as fast as it is capable of running. If your cart already has a speed code in it it may not go any faster than what you currently have. Your battery pack, solenoid and motor have a lot to do with performance. If one of those parts are weak or starting to show signs of breaking down, this controller may see that as a problem and work improperly or not at all. Make sure all terminals are clean and making good contact. Same should be done with motor and solenoid wiring as well.